A 1970s split level house on a wooded hillside in Burnsville, Minnesota, in winter, bare oaks and snow, the wide Minnesota River valley in pale haze below

Furnace repair in Burnsville, MN, just across the river from our office

Burnsville is a short drive over the Minnesota River from our office, and a lot of its houses sit on hillsides with a walkout lower level. That changes where the cold gets in and where the furnace has to push air. We measure every level before we fix or replace anything.

  • About 6 miles from our office
  • Every level measured before a price
  • Mechanical permit filed with the city

Or call or text 952-555-0163

Book a heating visit in Burnsville

We usually answer the same day, and within the hour when a house has no heat.

No heat and someone at home is elderly, unwell or very young? Call or text now: 952-555-0163

Hillside houses, walkouts and more than two levels

A lot of our Burnsville calls are in houses built into a slope: a walkout lower level with big glass doors on the downhill side, a main floor above, and on some houses a split level with short runs of stairs between four floors. Each level sits at a different height in the house and loses heat in its own way, and the furnace has to serve all of them from one room.

The walkout is usually the cold one in winter. Part of it is below ground, part of it is a wall of glass, and cold air settles to the lowest level while warm air rises away from it. In a split level the top bedrooms can run warm while the family room on the lowest floor stays cool, all on one thermostat. Neither is fixed by turning the furnace up. We measure each level and the airflow at every register, then balance the dampers, add return air where the house is missing it and seal the trunk.

Summer brings its own calls here: upper levels that catch the afternoon sun, and condensers in yards where the cottonwoods shed in early summer. A coil packed with fluff runs hot and quits on the worst afternoon. A spring check catches it, and the same visit looks at the furnace before fall.

When a furnace does need replacing, we size it by a room by room heat loss calculation to the Minnesota code design temperature for the Twin Cities of minus 15. The recent winters have tested that: on January 30, 2019, the Twin Cities airport recorded minus 28, the coldest reading there since 2010.

Two technicians in plain walnut-brown work shirts setting a new high-efficiency gas furnace in an unfinished basement, the old rusty furnace on a hand truck nearby

Permits for a replacement

Burnsville Building Inspections, at 100 Civic Center Parkway, lists furnace and air conditioning work and gas piping among the projects that need a mechanical permit. We file it and arrange the inspection.

Who can apply online

The city says licensed contractors and homeowners can apply online through its permit portal: businesses with a mechanical contractor's bond, and homeowners for work on their own property. If you are doing part of a job yourself, the permit is still yours to pull.

Check who you hire

Minnesota has no state license for heating contractors. Anyone contracting for heating, cooling or gas work files a mechanical contractor bond with the Department of Labor and Industry. Ask for it before work starts.

The rest of our area

We also work in Minneapolis, Edina, Richfield and Eden Prairie, and in Bloomington itself, where our office is. Every town page names the office that permits a new system there.

From our Bloomington office to Burnsville: how a visit goes

Burnsville is about 6 miles from our office in Bloomington, just across the Minnesota River, and 8 to 15 minutes for most addresses. We set the arrival window when you call, and we tell you plainly if a cold snap has pushed it back.

  1. You call, text or send the form.

    Tell us the address and which floor is the problem.

  2. We measure the whole house.

    Furnace, ducts, every register, basement to bedrooms.

  3. We show you the numbers.

    The heat loss, what is wrong and a written price.

  4. We fix it and check every floor.

    If a permit is needed, we pull it with the city.

Book a heating visit

Heating and cooling work we do in Burnsville homes

A cold walkout or lower level

Airflow measured at every register, returns added where the house is missing them, dampers set level by level.

An AC that quits in July

Capacitors, contactors, fan motors and coils packed with cottonwood, found and fixed the same visit when we have the part.

A furnace that will not light

Ignitors, flame sensors, pressure switches and inducer motors, found and shown to you before anything is replaced.

A spring and a fall check

The condenser before summer and the furnace and carbon monoxide alarms before the first cold night.

Run by its owner, from our Bloomington office

Kari Lindgren, owner of North Wren HVAC, in the basement shop with sheet metal behind her

Kari Lindgren, owner and lead technician

Kari answers the phone, does the load calculation and writes the price. You deal with her from the first call to the last check of the bedrooms.

Book a heating visit in Burnsville

We usually answer the same day, and within the hour when a house has no heat.

No heat and someone at home is elderly, unwell or very young? Call or text now: 952-555-0163

Before you call about heat in Burnsville

Do I need a permit to replace a furnace or AC in Burnsville?

Yes. Burnsville lists furnace and air conditioning work and gas piping among the projects that need a mechanical permit. Contractors and homeowners can both apply online. We file ours and arrange the inspection. See furnace replacement.

Why is our walkout level so cold?

Cold air settles to the lowest level, part of the walls are below ground and the glass doors lose heat fast, while warm air rises away. The level often has too few supply runs and no return. We measure it and show you what fixes it. See duct sealing and balancing.

Our split level is hot upstairs and cold downstairs. Can one furnace fix that?

Usually, once the air is going to the right places. Balancing dampers, return air from the top level and a fan setting that keeps air moving between floors close most of the gap. If it is still more than a few degrees, a second zone is the next step. See balancing.

Why does our AC keep quitting on hot afternoons?

Often a weak capacitor or a condenser coil packed with cottonwood fluff, which makes the unit run hot. We check both and clean the coil. A spring check heads it off. See AC repair.

How fast can you get to Burnsville when the heat is out?

It is 8 to 15 minutes from our office, so on most days we can be there the same day. Tell us if anyone in the house is elderly, unwell or very young and we will put you first. Call or text 952-555-0163. See furnace repair.

Call or text 952-555-0163

Tell us which floor of your Burnsville house is cold

Send it to Kari

We usually answer the same day, and within the hour when a house has no heat.

No heat and someone at home is elderly, unwell or very young? Call or text now: 952-555-0163

Call or text 952-555-0163