A snowy south Minneapolis street of 1920s houses and bare trees, the downtown Minneapolis skyline small in the distance under a pale winter sky

Furnace repair in Minneapolis, MN, from the basement to the top floor

A lot of Minneapolis houses are older than the furnace in their basement by fifty years or more, and the ductwork shows it. We measure every floor, find out why the top of the house stays cold, and then tell you whether the answer is a repair, a duct fix or a new system.

  • About 12 miles from our office
  • Every floor measured before a price
  • City permit filed for a replacement

Or call or text 952-555-0163

Book a heating visit in Minneapolis

We usually answer the same day, and within the hour when a house has no heat.

No heat and someone at home is elderly, unwell or very young? Call or text now: 952-555-0163

Old houses, and ductwork that came later

Many of the Minneapolis houses we work in were built long before forced air was the normal way to heat a home. The Lynnhurst Residential Historic District east of Lake Harriet, to take one neighborhood the city documents, was built almost entirely between 1893 and 1937. The furnace in a house that age is rarely the first one, and the ducts it feeds were often added, rerouted and patched by different hands over the decades.

That is where the cold top floor usually comes from. On calls we find supply runs squeezed up through old chases, a whole second floor fed from the far end of one long trunk, upstairs rooms with no return at all, and joints in the basement ceiling that have pulled apart. Add the stack effect, where warm air rises and leaks out the top of the house while cold air is pulled in at the bottom, and the bedrooms under the roof lose the fight every January.

The other thing we see is size. An older replacement was often picked to match the label on the furnace it replaced, and that one was sized for a house with less insulation and leakier windows. Minnesota's residential energy code now asks for equipment to be sized from a heat loss calculation and caps heating oversizing at 40 percent of the calculated load. A furnace far past that short cycles: it heats the air near the thermostat fast, shuts off, and never pushes enough warm air to the far rooms.

So we start with numbers. We measure the temperature on every floor and the airflow at the registers, do a room by room heat loss calculation to the code's winter design temperature for the Twin Cities of minus 15 degrees, and show you what is wrong before we write a price. Sometimes the answer is a sealed and rebalanced duct system and the furnace stays. Sometimes it is a smaller furnace, or a cold climate heat pump with the furnace kept for the coldest nights.

An upstairs bedroom in a 1920s Minneapolis house in winter, sloped plaster ceiling, a quilt on the bed, a small floor register and frost on the lower window panes

Permits for a replacement

The city's Development Review office in the Public Service Building, 505 Fourth Ave. S., issues mechanical permits, and the city says most heating, air conditioning, ventilation and gas piping work requires one. Residential HVAC replacement is a permit type on its online system. We file it for you.

Check who you hire

Minnesota has no state license for heating contractors. Anyone contracting for heating, cooling or gas work has to file a mechanical contractor bond with the Department of Labor and Industry. Ask for it before work starts, and that includes us.

The cold record

The coldest reading in the Minneapolis and St. Paul weather record, kept since 1872, is minus 41 degrees on January 21, 1888. Nobody sizes a furnace for that, but it is why the code design day is minus 15 and not zero.

The rest of our area

We also work in Edina, Richfield, Eden Prairie and Burnsville, and in Bloomington itself, where our office is. Every town page names the office that permits a new system there.

From our Bloomington office to Minneapolis: how a visit goes

Downtown Minneapolis is about 12 miles from our office in Bloomington, 18 to 30 minutes depending on traffic and which neighborhood you are in. South Minneapolis is closer than that. We set the arrival window when you call, and we tell you plainly if a cold snap has pushed it back.

  1. You call, text or send the form.

    Tell us the address and which floor is the problem.

  2. We measure the whole house.

    Furnace, ducts, every register, basement to bedrooms.

  3. We show you the numbers.

    The heat loss, what is wrong and a written price.

  4. We fix it and check every floor.

    If a permit is needed, we pull it with the city.

Book a heating visit

Heating and cooling work we do in Minneapolis homes

A top floor that never warms up

Disconnected runs, missing returns and unbalanced branches found by measuring airflow at every register, then sealed and rebalanced.

A furnace that will not light

Ignitors, flame sensors, pressure switches and inducer motors, found, shown to you and fixed the same visit when we have the part.

An old furnace sized by its label

A room by room heat loss calculation before we quote a replacement, so the new furnace fits the house you have now.

A heat pump in an older house

A cold climate heat pump on the existing ducts, with the gas furnace kept as backup for the coldest stretch.

Run by its owner, from our Bloomington office

Kari Lindgren, owner of North Wren HVAC, in the basement shop with sheet metal behind her

Kari Lindgren, owner and lead technician

Kari answers the phone, does the load calculation and writes the price. You deal with her from the first call to the last check of the bedrooms.

Book a heating visit in Minneapolis

We usually answer the same day, and within the hour when a house has no heat.

No heat and someone at home is elderly, unwell or very young? Call or text now: 952-555-0163

Before you call about heat in Minneapolis

Do I need a permit to replace my furnace in Minneapolis?

Yes. The city says most heating, air conditioning, ventilation and gas piping work requires a permit, and residential HVAC replacement is a permit type on its online system. We file it with Development Review and arrange the inspection. See furnace replacement.

Why is our top floor so much colder than the rest of the house?

Usually three things at once: warm air rising and leaking out the top of the house, upstairs supply runs that are long, crushed or disconnected, and too little return air from the upper floor. We measure each one so you can see which matters most in your house. See duct sealing and balancing.

Is my old furnace too big for the house?

Often, in older city houses that have had insulation and windows upgraded since the furnace was picked. A heat loss calculation answers it. Minnesota code caps heating oversizing at 40 percent of the calculated load, and a furnace far past that tends to short cycle. See how we size a furnace.

Can a heat pump heat an older Minneapolis house?

Many can carry most of the winter. A cold climate model keeps a good share of its capacity at 5 degrees, and the furnace takes over below the temperature we set together. Whether your ducts can carry the airflow is something we measure first. See cold climate heat pumps.

How fast can you get to Minneapolis when the heat is out?

It is 18 to 30 minutes from our office, so on most days we can be there the same day. Tell us if anyone in the house is elderly, unwell or very young and we will put you first. Call or text 952-555-0163. See furnace repair.

Call or text 952-555-0163

Tell us which floor of your Minneapolis house is cold

Send it to Kari

We usually answer the same day, and within the hour when a house has no heat.

No heat and someone at home is elderly, unwell or very young? Call or text now: 952-555-0163

Call or text 952-555-0163